Re: Need Reassurance for using DragonFly for Prodduction

["Siju George" <sgeorge.ml@xxxxxxxxx>]

On 4/8/07, Bill Hacker <wbh@conducive.org> wrote:
> Siju George wrote:
>
> *snip*
>
> > Does it run quite Well on Intel's Core2Duo
>
> 1.8 Runs fine here on Core-D, both dual & single core, 2.8 & 3.0 GHz, tested
> with 1 GB SDRAM, DDR 266, & 2 GB DDR2 @ 800 MHz fsb. Tyan, Asus, MSi, et al.
>
> Should be no problem on Core-2 Duo & 1024 MHz fsb with commodity hardware of
> decent grade.
>
> Runs well at the other end of the performance spectrum on VIA C3 also.
>
> Been a while since I did a NetBSD install, but ISTR that DragonFly is easier by
> comparison.
>
> Either way, it makes life simpler to have a FreeBSD 6 or 7 CD around with
> 'sysinstall' to do the disk slicing & MBR setup beforehand.

Thankyou so much bill for the input :-)

Kind Regards

Siju