1.4.3: Installer hangs at timezone selection

[Oliver Fromme <check+ixjt6r00rst8bncd@xxxxxxxxxx>]

Hi,

Is this the correct group for reporting installation
problems?

I just tried to install 1.4.3 for testing purposes within
qemu.  I downloaded the iso and booted it, started the
installer and went through a standard installation, which
seemed to work fine.

Afterwards (still in the installer) I went through the
configuration steps ...  It asked me for UTC or local time
clock, I answered UTC, then it presented a list of time
zones, I selected "Europe" -- and then it hung:  Empty blue
screen, only with the "F10=..." line at the top and the
(empty) help line at the bottom.

When I switched to vty0 (Alt-F1), I discovered that the
kernel had reported that "dfuife_curses" was aborted on
signal 11 (SIGSEGV).  I had to abort the installer with
Ctrl-C, because it was impossible to revive.

However, when I rebooted, the newly installed system went
up fine, so the installation was successful.  The file
/etc/wall_cmos_clock did exist, but no /etc/localtime
file.

Best regards
   Oliver

-- 
Oliver Fromme,  secnetix GmbH & Co. KG, Marktplatz 29, 85567 Grafing
Dienstleistungen mit Schwerpunkt FreeBSD: http://www.secnetix.de/bsd

Any opinions expressed in this message may be personal to the author
and may not necessarily reflect the opinions of secnetix in any way.