DragonFly On-Line Manual Pages
FVWMGTKDEBUG(1) FVWM Module FVWMGTKDEBUG(1)
FvwmGtkDebug - graphical interactive FVWM module debugger
FvwmGtkDebug should be spawned by fvwm(1).
To run this module, place this command somewhere in the configuration:
To stop this module, just close the GUI window, the usual KillModule
You may also run this application in the dummy mode from the command
line, but this only shows the GUI with dummy event data and not the
This module monitors all fvwm event information and shows it nicely in
the interactive gtk+ application. Good for debugging purposes.
There are several command line switches:
FvwmGtkDebug [ --mask mask ] [ --xmask mask ] [ --debug level ]
Long switches may be abbreviated to shorter switches.
-m|--mask mask - set the initial module mask, 31 bit integer. This
mask may be changed interactively at any time. By default almost all
events are monitored (except for some flood events like
CONFIGURE_WINDOW or FOCUS_WINDOW. The special value of -1 sets the
-x|--xmask mask - set the initial module extended mask, 31 bit integer.
This mask may be changed interactively at any time. By default almost
all events are monitored (except for some flood events like
ENTER_WINDOW or LEAVE_WINDOW. The special value of -1 sets the maximal
-d|--debug level - use the Perl library debugging mechanism. The
useful levels are 2 to 4.
See also FvwmDebug.
Mikhael Goikhman <firstname.lastname@example.org>.
perl v5.8.0 2003-06-10 FVWMGTKDEBUG(1)