Copyright (c) 2003-2009 The DragonFly Project. Copyright (c) 1992-2003 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. DragonFly 2.3.1-DEVELOPMENT #38: Sat Jun 27 20:39:09 EEST 2009 hasso@lab-df2.estpak.ee:/usr/obj/home/hasso/dragonfly-src/sys/GENERIC TSC clock: 3000212001 Hz, i8254 clock: 1193183 Hz CPU: Intel(R) Xeon(R) CPU E3110 @ 3.00GHz (3000.22-MHz 686-class CPU) Origin = "GenuineIntel" Id = 0x10676 Stepping = 6 Features=0xbfebfbff Features2=0x8e3fd Hyperthreading: 2 logical CPUs real memory = 2146115584 (2095816K bytes) avail memory = 2069438464 (2020936K bytes) madt: RSDP not in EBDA madt: RSDP in BIOS mem madt: MADT in XSDT madt: LAPIC address 0xfee00000, flags 0x1 lapic: at 0xfee00000 madt: BSP apic id 0 madt: cpu_id 1, apic_id 0 madt: cpu_id 2, apic_id 1 Changing APIC ID for IO APIC #0 from 0 to 2 on chip Programming 24 pins in IOAPIC #0 lapic: divisor index 0, frequency 166678860 Hz DragonFly/MP: Multiprocessor motherboard cpu0 (BSP): apic id: 0, version: 0x00050014 cpu1 (AP): apic id: 1, version: 0x00050014 io0 (APIC): apic id: 2, version: 0x00170020, at 0xfec00000 APIC_IO: Testing 8254 interrupt delivery APIC_IO: routing 8254 via IOAPIC #0 intpin 2 SMP: AP CPU #1 Launched! objcache(exec-args): too small for ncpus, adjusting cluster_limit 16->32 Preloaded elf kernel "/boot/kernel" at 0xc082a000. Preloaded elf module "/boot/modules/acpi.ko" at 0xc082a218. Pentium Pro MTRR support enabled md0: Malloc disk pcibios: BIOS version 3.00 Using $PIR table, 10 entries at 0xc00fa9c0 ACPI: RSDP @ 0x0xf2980/0x0024 (v 2 DELL ) ACPI: XSDT @ 0x0xf2a08/0x0094 (v 1 DELL PE_SC3 0x00000001 DELL 0x00000001) ACPI: FACP @ 0x0xf2b20/0x00F4 (v 3 DELL PE_SC3 0x00000001 DELL 0x00000001) ACPI: DSDT @ 0x0x7fec8000/0x2545 (v 1 DELL PE_SC3 0x00000001 INTL 0x20050624) ACPI: FACS @ 0x0x7fee7c00/0x0040 ACPI: APIC @ 0x0xf2c14/0x0072 (v 1 DELL PE_SC3 0x00000001 DELL 0x00000001) ACPI: SPCR @ 0x0xf2c93/0x0050 (v 1 DELL PE_SC3 0x00000001 DELL 0x00000001) ACPI: HPET @ 0x0xf2ce3/0x0038 (v 1 DELL PE_SC3 0x00000001 DELL 0x00000001) ACPI: MCFG @ 0x0xf2d1b/0x003C (v 1 DELL PE_SC3 0x00000001 DELL 0x00000001) ACPI: WD__ @ 0x0xf2d57/0x0134 (v 1 DELL PE_SC3 0x00000001 DELL 0x00000001) ACPI: SLIC @ 0x0xf2e8b/0x0024 (v 1 DELL PE_SC3 0x00000001 DELL 0x00000001) ACPI: ERST @ 0x0x7fecb114/0x0210 (v 1 DELL PE_SC3 0x00000001 DELL 0x00000001) ACPI: HEST @ 0x0x7fecb324/0x027C (v 1 DELL PE_SC3 0x00000001 DELL 0x00000001) ACPI: BERT @ 0x0x7fecaf94/0x0030 (v 1 DELL PE_SC3 0x00000001 DELL 0x00000001) ACPI: EINJ @ 0x0x7fecafc4/0x0150 (v 1 DELL PE_SC3 0x00000001 DELL 0x00000001) ACPI: SSDT @ 0x0x7feca545/0x0266 (v 1 DELL PE_SC3 0x00000011 INTL 0x20050624) ACPI: SSDT @ 0x0x7feca9bb/0x0266 (v 1 DELL PE_SC3 0x00000011 INTL 0x20050624) ACPI: SSDT @ 0x0x7fecae31/0x0162 (v 1 DELL PE_SC3 0x00000010 INTL 0x20050624) npx0: on motherboard npx0: INT 16 interface Using XMM optimized bcopy/copyin/copyout acpi0: on motherboard acpi0: Power Button (fixed) Warning: ACPI is disabling APM's device. You can't run both unknown: memory range not supported unknown: memory range not supported acpi_timer0: <24-bit timer at 3.579545MHz> port 0x808-0x80b on acpi0 acpi_hpet0: iomem 0xfed00000-0xfed003ff on acpi0 acpi_hpet0: frequency 14318180 cpu0: on acpi0 cpu_cst0: on cpu0 cpu_pst0: on cpu0 cpu1: on acpi0 cpu_cst1: on cpu1 cpu_pst1: on cpu1 fdc0: ready for input in output fdc0: cmd 3 failed at out byte 1 of 3 sio0 port 0x3f8-0x3ff irq 4 on acpi0 sio0: type 16550A sio1: can't drain, serial port might not exist, disabling fdc0: ready for input in output fdc0: cmd 3 failed at out byte 1 of 3 legacypci0 on motherboard pcib0: on legacypci0 pci0: on pcib0 pcib1: irq 2 at device 1.0 on pci0 pci1: on pcib1 pcib2: irq 2 at device 28.0 on pci0 pci2: on pcib2 pcib3: irq 2 at device 28.4 on pci0 pci3: on pcib3 bge0: mem 0xdfdf0000-0xdfdfffff irq 2 at device 0.0 on pci3 bge0: CHIP ID 0x42010000; ASIC REV 0x04; CHIP REV 0x42; PCI-E alignment check failed miibus0: on bge0 brgphy0: on miibus0 brgphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto ACPI: no P-State CPU driver bge0: MAC address: 00:21:9b:fd:18:2c pcib4: irq 5 at device 28.5 on pci0 pci4: on pcib4 bge1: mem 0xdfef0000-0xdfefffff irq 5 at device 0.0 on pci4 bge1: CHIP ID 0x42010000; ASIC REV 0x04; CHIP REV 0x42; PCI-E alignment check failed alignment check failed miibus1: on bge1 brgphy1: on miibus1 brgphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto bge1: MAC address: 00:21:9b:fd:18:2d uhci0: port 0xdc60-0xdc7f irq 6 at device 29.0 on pci0 usb0: on uhci0 usb0: USB revision 1.0 uhub0: on usb0 uhub0: 2 ports with 2 removable, self powered uhci1: port 0xdc80-0xdc9f irq 10 at device 29.1 on pci0 usb1: on uhci1 usb1: USB revision 1.0 uhub1: on usb1 uhub1: 2 ports with 2 removable, self powered uhci2: port 0xdca0-0xdcbf irq 6 at device 29.2 on pci0 usb2: on uhci2 usb2: USB revision 1.0 uhub2: on usb2 uhub2: 2 ports with 2 removable, self powered pci0: at 29.7 irq 6 pcib5: at device 30.0 on pci0 pci5: on pcib5 pci5: at 5.0 irq 13 isab0: at device 31.0 on pci0 isa0: on isab0 atapci0: port 0xdc50-0xdc5f,0xdc40-0xdc4f,0xdc2c-0xdc2f,0xdc38-0xdc3f,0xdc28-0xdc2b,0xdc30-0xdc37 irq 11 at device 31.2 on pci0 ata2: on atapci0 ad4: 238475MB at ata2-master SATA150 acd0: CDRW at ata2-slave SATA150 ata3: on atapci0 ad6: 238418MB at ata3-master SATA300 orm0: