Re: re(4) watchdog timeouts after a short time

[Joe Talbott <josepht@xxxxxxxxxx>]

On Wed, Dec 03, 2008 at 09:16:28AM +0800, Sepherosa Ziehau wrote:
> On Wed, Dec 3, 2008 at 7:00 AM, Joe Talbott <josepht@cstone.net> wrote:
> > I upgraded my 2.1-DEVELOPMENT box from 2.1-DEVELOPMENT from several
> > months ago and my re(4) a RTL8101E card only works for a few seconds
> > after boot.  After which I get watchdog timeouts and am unable to ping
> > a remote host.  I was unable to get any information from tcpdump.
> > Here is the relevant verbose dmesg output and sysctl output.  I have
> > tried disabling rx/tx csum and vlan{mtu,hwtagging} all to no avail.  Let
> > me know what further info is needed.
> >
> > re0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
> >        options=1b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING>
> >        inet6 fe80::2a0:d1ff:fe60:25a3%re0 prefixlen 64 scopeid 0x1
> >        inet x.x.x.x netmask 0xffffffc0 broadcast x.x.x.x
> >        ether 00:a0:d1:60:25:a3
> >        media: Ethernet autoselect (100baseTX <full-duplex>)
> >        status: active
> 
> Does sysctl hw.re0.imtype=0 help?

I failed to mention I tried that as well.  It did not work.

Thanks,
Joe