DragonFly On-Line Manual Pages

Search: Section:  


ZMQ_TIPC(7)                       0MQ Manual                       ZMQ_TIPC(7)

NAME

zmq_tipc - 0MQ unicast transport using TIPC

SYNOPSIS

TIPC is a cluster IPC protocol with a location transparent addressing scheme.

ADDRESSING

A 0MQ endpoint is a string consisting of a transport:// followed by an address. The transport specifies the underlying protocol to use. The address specifies the transport-specific address to connect to. For the TIPC transport, the transport is tipc, and the meaning of the address part is defined below. Assigning a port name to a socket When assigning a port name to a socket using _zmq_bind()_ with the 'tipc' transport, the 'endpoint' is defined in the form: {type, lower, upper} * Type is the numerical (u32) ID of your service. * Lower and Upper specify a range for your service. Publishing the same service with overlapping lower/upper ID's will cause connection requests to be distributed over these in a round-robin manner. Connecting a socket When connecting a socket to a peer address using zmq_connect() with the tipc transport, the endpoint shall be interpreted as a service ID, followed by a comma and the instance ID. The instance ID must be within the lower/upper range of a published port name for the endpoint to be valid.

EXAMPLES

Assigning a local address to a socket. // Publish TIPC service ID 5555 rc = zmq_bind(socket, "tipc://{5555,0,0}"); assert (rc == 0); // Publish TIPC service ID 5555 with a service range of 0-100 rc = zmq_bind(socket, "tipc://{5555,0,100}"); assert (rc == 0); Connecting a socket. // Connect to service 5555 instance id 50 rc = zmq_connect(socket, "tipc://{5555,50}"); assert (rc == 0);

SEE ALSO

zmq_bind(3) zmq_connect(3) zmq_tcp(7) zmq_pgm(7) zmq_ipc(7) zmq_inproc(7) zmq(7)

AUTHORS

This page was written by the 0MQ community. To make a change please read the 0MQ Contribution Policy at http://www.zeromq.org/docs:contributing. 0MQ 4.1.0 08/17/2015 ZMQ_TIPC(7)

Search: Section: