DragonFly On-Line Manual Pages


STGE(4) 	      DragonFly Kernel Interfaces Manual	       STGE(4)

NAME

stge -- Sundance/Tamarack TC9021 Gigabit Ethernet device

SYNOPSIS

device miibus device stge Alternatively, to load the driver as a module at boot time, place the following line in /boot/loader.conf: if_stge_load="YES"

DESCRIPTION

The stge driver supports the Sundance/Tamarack TC9021 Gigabit Ethernet chip. It uses an external PHY or an external 10-bit interface. The stge driver also supports IP/UDP/TCP checksum offload, VLAN tag- ging/insertion and JUMBO frame. For more information on configuring this device, see ifconfig(8). The stge driver supports polling(4).

HARDWARE

The stge driver supports the Sundance/Tamarack TC9021 based Gigabit Eth- ernet adapters, including the following: * Antares Microsystems Gigabit Ethernet * ASUS NX1101 Gigabit Ethernet * D-Link DGE-550T Gigabit Ethernet * IC Plus IP1000A Gigabit Ethernet * Sundance ST-2021 Gigabit Ethernet * Sundance ST-2023 Gigabit Ethernet * Sundance TC9021 Gigabit Ethernet * Tamarack TC9021 Gigabit Ethernet

SEE ALSO

arp(4), ifmedia(4), miibus(4), netintro(4), ng_ether(4), polling(4), vlan(4), ifconfig(8)

HISTORY

The stge device driver first appeared in NetBSD 1.6.

AUTHORS

The stge driver was written by Jason R. Thorpe <thorpej@NetBSD.org> and improved by Pyun YongHyeon <yongari@freebsd.org>. DragonFly 3.9 November 2, 2006 DragonFly 3.9