DragonFly On-Line Manual Pages

Search: Section:  


SICONTROL(8)	       DragonFly System Manager's Manual	  SICONTROL(8)

NAME

sicontrol -- Specialix SI/XIO driver configuration and debugging

SYNOPSIS

sicontrol device command [param ...]

DESCRIPTION

The sicontrol utility is used to configure and monitor the SI/XIO device driver. The sicontrol utility operates on the specified device to indicate which port is to be used. The special device string `-' is used to indicate the global driver set- tings instead. A /dev/ is included if necessary. The following commands are used for the global settings and should be specified with the '-' device name: int_throttle [value] Configure the `aggregate interrupt throttle value'. The maximum number of host adapter interrupts per second is determined by: controller CPU clock / (8 * int_throttle) The default value at boot time is 25000. The host adapter cpu clock is 25MHz. This gives a maximum interrupt rate of about 125 interrupts per second. Lowering this value will increase the rate in which the host adapter can interrupt the operating system for attention. rxint_throttle [value] Configure the receiver interrupt throttle value. The default value of 4 at boot time allows an interrupt rate of approximately 25. Lowering this value will increase the rate in which the host adapter can interrupt the operating system to empty the receiver fifos. nport Return the number of ports under the control of the device driver. The following commands are used for the individual ports and should be specified with a device name from /dev: mstate Show the current incoming modem control signals. ccbstat Show the current "ccb" structure for the specified port. This is not of much use outside of debugging the driver and determining why a port is wedged. ttystat Show the current "tty" structure that the kernel has for the speci- fied port. This is not much use outside of debugging the driver.

FILES

/dev/si_control global driver control file for use by sicontrol /dev/ttyA* terminal control ports /dev/ttyiA* initial termios state devices, for use by stty(1) /dev/ttylA* locked termios state devices, for use by stty(1)

DIAGNOSTICS

Generally self explanatory.....

SEE ALSO

stty(1), si(4), termios(4), tty(4), comcontrol(8)

HISTORY

The sicontrol utility is loosely based on a utility called siconfig which was written by Andy Rutter <andy@acronym.co.uk> Specialix International do not support this device driver in any way.

AUTHORS

Peter Wemm <peter@FreeBSD.org>

BUGS

Bound to be many... :-) DragonFly 5.3 September 26, 1995 DragonFly 5.3

Search: Section: