DragonFly On-Line Manual Pages

Search: Section:  

mlabel(1)              DragonFly General Commands Manual             mlabel(1)

Name
       mlabel - make an MSDOS volume label

Note of warning
       This manpage has been automatically generated from mtools's texinfo
       documentation, and may not be entirely accurate or complete.  See the
       end of this man page for details.

Description
       The mlabel command adds a volume label to a disk. Its syntax is:
       mlabel [-vcsn] [-N serial] drive:[new_label]

       Mlabel displays the current volume label, if present. If new_label is
       not given, and if neither the c nor the s options are set, it prompts
       the user for a new volume label.  To delete an existing volume label,
       press return at the prompt.

       Reasonable care is taken to create a valid MS-DOS volume label.  If an
       invalid label is specified, mlabel changes the label (and displays the
       new label if the verbose mode is set). Mlabel returns 0 on success or 1
       on failure.

       Mlabel supports the following options:

       c      Clears an existing label, without prompting the user

       s      Shows the existing label, without prompting the user.

       n      Assigns a new (random) serial number to the disk

       N serial
              Sets the supplied serial number. The serial number should be
              supplied as an 8 digit hexadecimal number, without spaces

See Also
       Mtools' texinfo doc

Viewing the texi doc
       This manpage has been automatically generated from mtools's texinfo
       documentation. However, this process is only approximative, and some
       items, such as crossreferences, footnotes and indices are lost in this
       translation process.  Indeed, these items have no appropriate
       representation in the manpage format.  Moreover, not all information
       has been translated into the manpage version.  Thus I strongly advise
       you to use the original texinfo doc.  See the end of this manpage for
       instructions how to view the texinfo doc.

       *      To generate a printable copy from the texinfo doc, run the
              following commands:

                     ./configure; make dvi; dvips mtools.dvi

       *      To generate a html copy,  run:

                     ./configure; make html

              A premade html can be found at
              `http://www.gnu.org/software/mtools/manual/mtools.html'

       *      To generate an info copy (browsable using emacs' info mode),
              run:

                     ./configure; make info

       The texinfo doc looks most pretty when printed or as html.  Indeed, in
       the info version certain examples are difficult to read due to the
       quoting conventions used in info.

mtools-4.0.10                       10Mar09                          mlabel(1)

Search: Section: