DragonFly On-Line Manual Pages

Search: Section:  


GIT-MKTAG(1)                      Git Manual                      GIT-MKTAG(1)

NAME

git-mktag - Creates a tag object with extra validation

SYNOPSIS

git mktag

DESCRIPTION

Reads a tag contents on standard input and creates a tag object. The output is the new tag's <object> identifier. This command is mostly equivalent to git-hash-object(1) invoked with -t tag -w --stdin. I.e. both of these will create and write a tag found in my-tag: git mktag <my-tag git hash-object -t tag -w --stdin <my-tag The difference is that mktag will die before writing the tag if the tag doesn't pass a git-fsck(1) check. The "fsck" check done mktag is stricter than what git-fsck(1) would run by default in that all fsck.<msg-id> messages are promoted from warnings to errors (so e.g. a missing "tagger" line is an error). Extra headers in the object are also an error under mktag, but ignored by git-fsck(1). This extra check can be turned off by setting the appropriate fsck.<msg-id> varible: git -c fsck.extraHeaderEntry=ignore mktag <my-tag-with-headers

OPTIONS

--strict By default mktag turns on the equivalent of git-fsck(1) --strict mode. Use --no-strict to disable it.

TAG FORMAT

A tag signature file, to be fed to this command's standard input, has a very simple fixed format: four lines of object <hash> type <typename> tag <tagname> tagger <tagger> followed by some optional free-form message (some tags created by older Git may not have tagger line). The message, when it exists, is separated by a blank line from the header. The message part may contain a signature that Git itself doesn't care about, but that can be verified with gpg.

GIT

Part of the git(1) suite Git 2.41.0 2023-06-01 GIT-MKTAG(1)

Search: Section: